Product category
  • Servos
    Micro Servo
    MiNi Servo
    Wing Servo
    Low Profile Servo
    Standard Servo
    Large Size Servo
  • Electronic speed controller
    ESC Part
  • Motors
  • Gyro
  • RC Accessories
    Metal servo Arm
    Cooling Fan & Heatsink
    Wire & Connectors
  • Screw & Plug
    Screw set
    Button Head Screw
    Flat Head Screw
    Cap Head Screw
Product description

Product description


Color: Blue
Weight:g: 13.5
Size:mm: 25.6x24.5x10
Spec. & Description
Product comment(0)

OMG Drift Tuned Gyro For Competition Drifting

Product Description

V2 RPG-302   new high-voltage   version   gyroscope adapts aluminum case and has digital and   analog mode. Advantage   of being compatible with high voltage:

ESC can open 7.4V BEC   power   supply,   high   voltage   servo   can work in 7.4V environment, and the strength and speed are much higher than the 6V environment.

Friendly Tip: The built-in sensitivity adjustment knob of   the gyroscope is made of plastic and the range of rotation is Limit, so   please use the special   slotted

screwdriver to adjust. When it is   tightened,   don't   forcefully   continue   to   screw, otherwise it will be damaged!

LED Status Display

Fast blink                Initialization

Slow blink               Self sensitivity adjustment                        Sensitivity line stop

Constant blink        Transmitter sensitivity adjustment           Sensitivity line work

Function of gyroscope:

The gyroscope belongs to auxiliary device of steering gear,   which can be used to correct the   deviation   or   excessive   tail of RC car.   It is   commonly used for

drift or F1 car models. The   Gyro   can   apply   to   any   models   theoretically,   but the actual effect depends on the setting of the Gyro (such as setting of

sensitivity / correction direction).


Switch 1: Servo Type setting, flip switch up for analog servos, down for digital servos.

Switch 2: Sensitivity direction setting, flip switch up for opposite direction, down for positive direction.

1. Quick flash when power on means the gyro is initializing and will calibrate a middle

point   of   the   gyro   and   the   remote   controller's   direction   channel. Don't   move the gyroscope and change the direction channel of remote controller.

2. When   the   LED   stops   blinking   and   is   constantly   lit,   it   means   that   the signal of sensitivity setting channel has been received.   The   sensitivity   can   be

set by remote controller   and   the   servo   output   range   can   be   set   by   the   potentiometer   on   the gyroscope, increasing the output value towards clockwise


3.If LED   blinks   slowly,   it means that the signal of sensitivity setting channel has not been   received.   The   sensitivity   can   be   set   by   the potentiometer on

the gyroscope, clockwise increasing Maximum value of sensitivity and servo range.